Trinity United Church: Beeton, Ontario. Designer Epoxy

Designer Epoxy Project at Trinity United Church

This project was one of our favorite to work on. The staff at Trinity United Church in Beeton were very friendly and hospitable.  Our goal was to remove all the old coatings and create a beautiful new brighter epoxy finishing.  We also added in a custom epoxy logo to the center of the main room to add our unique touch!

Before We Started

When we arrived, the floor was fairly well leveled but had many imperfections.  There were varying colors between places, and the old paint was applied to a floor that was not properly prepared.  This caused some peeling and imperfection over time.

Old kitchen imperfections

Old kitchen imperfections

Varying Colors Between Rooms

Varying Colors Between Rooms

Poor Quality Bathroom Floors

Poor Quality Bathroom Floors

Patches and Epoxy Primer

Patches and Epoxy Primer

Writing The Logo

Writing The Logo

Preparation and Epoxy Primer

After the floor was perfectly ground down, we patched everything and applied an epoxy primer to work as a concrete seal and close up all the pores.  We also drew out the custom logo and did the primary coat with a thick coat of light grey epoxy.

Clear Coat Applied On Logo For Contrast

Clear Coat Applied On Logo For Contrast

The Completed Designer Epoxy Job

Our final step was to put the main coat of premium light epoxy, and a couple coats of protective eurathane to preserve the life of the epoxy.  We loved the final product!

Main Room Light Grey Epoxy

Main Room Light Grey Epoxy

Finished Custom Logo

Finished Custom Logo

Thanks Trinity United Church! We hope you love your new floor!

Thanks Trinity United Church! We hope you love your new floor!